This is our new 300M Front Output Shaft for a Toyota 4 Cylinder T-case. As you all know it's becoming another weak link. This Output shaft is a stock replac..

Price: $300.00

Tired of shearing hub bolts? We designed a simple do-it-yourself drill guide plate to add four 5/16th dowl pins to your locking hub. This plate is made by a..

Price: $70.00

300M Dana 44 U-Joint. No bearings or bushings!

Longfields U-Joint are made from 300M material with caps made of 4340 chromoly. The legs and
caps are surfaced hardened and polished to eliminate the need for bearings or bushings.
The caps come with grease fittings, snap rings a..

Price: $155.00

Our new better 300M Dana 60 U-Joints now come with 1 grease fitting instead of 4, they are cross drilled which will give you more grease storage. We went with a high impact aluminum nickel bronze bushing.  These are much better for high..

Price: $190.00

This is a easy way to grease your inner spindle bearings or bushings. You just have to take the drive slug off and screw this onto the end of the spindle. Then pump it full of gr..

Price: $30.00

This is our new Dana 60 & Dana 44 Teflon spindle bushings. Like you I got tired of the needle bearings going to hell and damaging the stub shaft. So we came up with this one piece bushing and seal. This replaces the bearing and the thrust washer. They will last much longer than th..

Price: $40.00

These beadlocks come with an anti-coning ring to keep your outer ring from bending inward. These beadlocks are very easy to weld on, no cutting necessary on your rim. They come with 24 3/8 bolts, washers and a special locking nut.

International cred..

Price: $85.00